null

Faun Horns latex horn goat devil cosplay larp prosthetic halloween costume mens

Cottage Emporium - Wizafir

(No reviews yet) Write a Review
$13.95
Shipping:
Calculated at Checkout
Adding to cart… The item has been added

Product Overview

Faun Latex Horns

This prosthetic is handmade in the U.S. It is a hollow cast latex with fine blending edges.
Its a great addition for any Goat, Mr. Tumnus from Narnia, or Devil costume

Item Number:
Faun Horns
Size:
One Size Fits Most Adults
Color:
Neutral - natural skin tone
   
Material & Care:
Latex
Includes:
1 pair of ears (adhesive is not included)
Actual Measurements (measured flat):

Approximately 2 3/4" long
Additional Notes:  


 

You will also need to purchase the following: (not sold in our store)

  • Prosthetic adhesive (ex: spirit gum, pros-aide, etc.)
  • Adhesive remover

To apply: Clean skin with a non-greasy astringent and dry. Position the prosthetic over your ear and determine proper placement. Apply a thin layer of adhesive to the underside of the prosthetic piece and to the skin where the piece will be adhered. After the adhesive has dried, press the piece down firmly, especially around the edges.

Makeup application: After your prosthesis is firmly adhered, you can apply a sealer (pros-aide) to the piece and a little over the surrounding skin, then powder. You may then apply a makeup to blend, or skip the sealer and use rubber mask greasepaint to cover the piece and blend.

Removal: Using a Q-tip, apply a small amount of remover along the edge of the piece. Slowly lift an edge and start applying remover underneath the piece. Keep working it under until the entire piece is free.

Storage: After the piece has dried completely, powder the underside of the prosthetic where the adhesive was. Seal in a plastic bag and store in a cool, dry area out of direct sunlight.

 

This product contains Latex. Some individuals may have an allergic reaction to latex. Do NOT use this product if you experience discomfort. Product has been powdered with cornstarch during the demolding process to prevent sticking.

 

Since this product is hand made, the ears may have small bubbles or imperfections from the molding process.




Reviews

(No reviews yet) Write a Review